Pièces pour motos Honda
Choisissez votre modèle et l’année pour voir les pièces répertoriées pour votre moto.
Choisissez votre modèle et l’année pour voir les pièces répertoriées pour votre moto.
1968 Honda CB350K0 · Tools & Hardware Buying guide
The selected tools cover alternator rotor removal, the oil-filter rotor’s special lock nut and a rear wheel retaining ring. Check tool engagement and drive sizes before following the correct service procedure.
Alternator rotor puller16 × 1.5 threaded puller listed for the 1968–72 CB350K.Voir la pièce
Dual-ended rotor locknut tool20mm and 24mm ends with a 1/2-inch-drive extension interface; check nut engagement.Voir la pièce
Rear bearing-retainer toolFor retainers referenced to 41231-286-000 or 41231-429-000; 22mm hex and 3/8-inch square drives.Voir la pièce
Pièces connexes : 24mm socket with 3/8-inch drive · Genuine Honda 16mm rotor lock nut
The dual-ended special-nut tool has 20mm and 24mm ends for a 1/2-inch-drive extension. The linked single-ended socket has a 24mm inside diameter and 3/8-inch drive. Honda identifies the K0 oil-filter rotor fastener as a 16mm lock nut; the socket-end measurement and nut size describe different features.
A specialty tool is only one part of the repair. Identify the installed rotor or retainer, inspect its engagement surfaces and follow the Honda procedure for access, holding and removal. Avoid improvising with a punch or choosing a puller merely because its bolt appears similar.
The threaded puller is listed for CB350K 1968–72 and specifies 16 × 1.5. Confirm the installed rotor, particularly after an engine or alternator change, before selecting that thread.
Its stated job is removing the threaded bearing-retainer ring. It is not described as a bearing extractor, so plan the rest of the wheel service using the appropriate Honda procedure and equipment.
They cover several Honda applications. The K0 manual shows a 25mm circlip at the clutch center and a 16mm lock nut at the oil-filter rotor. Choose the socket for the actual fastener and engagement dimensions.
Envoyez-nous le modèle et l’année de votre moto, des photos de la pièce actuelle et les détails de toute modification par rapport au montage d’origine.
Sélectionnez le modèle exact et l’année pour affiner les résultats.
Choisissez votre modèle et l’année.