Pièces pour motos Honda
Choisissez votre modèle et l’année pour voir les pièces répertoriées pour votre moto.
Choisissez votre modèle et l’année pour voir les pièces répertoriées pour votre moto.
1972 Honda CB450K · Electrical Buying guide
The headlight plug and front brake-switch sub-harness have separate Honda references. Starter brushes specify their motor design and dimensions. Coil and charging choices provide other electrical requirements, so a shared motorcycle application does not replace checks at the equipment actually fitted.
OEM-style headlight wiring plugHeadlight plug referencing Honda 33130-300-003, listed for the 1972 CB450K. Compare the lamp connection and retained wiring. Its description does not supply a full terminal drawing or a complete replacement loom.Voir la pièce
Front stop-switch wiring sectionSub-harness referencing Honda 35345-319-000 for front brake-switch wiring. Compare the switch end, loom end and required route; no main harness or stop switch is itemized as supplied.Voir la pièce
Brush pair for a Mitsuba starterTwo 12 × 14 × 6mm brushes for Mitsuba two-brush starters, with one insulated and one non-insulated lead arrangement. References Honda 31201-292-158 / 31201-MG9-004. Check the starter retained on the motorcycle.Voir la pièce
Pièces connexes : Single-output ignition coil and lead checks · Lithium-only charging control · Left control with external wire routing
A headlight plug repairs the connection, while a bucket, rim or complete assembly addresses the lamp structure. The stock-type assembly’s CB450K note calls for reuse of the old headlight mounting bolts. Inspect the retained supports and fasteners before assuming that a wiring repair or assembled lamp covers every mounting requirement.
The lithium combination control specifies 14V ±0.2 and excludes standard lead-acid batteries. Confirm the set point against the lithium battery’s requirements. Lead-acid controls and rotor kits have their own battery restriction; match the version across the order rather than selecting solely from its motorcycle application.
Compare the lamp-side termination and retained wiring with the OEM-style plug. The listing gives reference 33130-300-003 but no full terminal dimensions or pin drawing. Confirm the needed connection details when the fitted lamp or wiring differs from the original arrangement.
Check the motor design, removed brush dimensions and lead arrangement directly. This set is specified for Mitsuba two-brush starters at 12 × 14 × 6mm. The motorcycle year cannot identify a different starter fitted during earlier repairs.
The replacement coil’s description requires reversed mounting because its leads exit differently. Compare the approximately 80mm mounting centres, attached wire paths and connectors together. Its 12V single-output and 5-ohm primary ratings also need to suit the ignition being retained.
Envoyez-nous le modèle et l’année de votre moto, des photos de la pièce actuelle et les détails de toute modification par rapport au montage d’origine.
Sélectionnez le modèle exact et l’année pour affiner les résultats.
Choisissez votre modèle et l’année.