Pièces pour motos Honda
Choisissez votre modèle et l’année pour voir les pièces répertoriées pour votre moto.
Choisissez votre modèle et l’année pour voir les pièces répertoriées pour votre moto.
1971 Honda CB350K3 · Ignition Buying guide
Right and left contact breakers are different parts. The replacement coil is sold individually, while the ignition switch requires the early round harness connector. An electronic-ignition conversion needs a separate compatibility check.
Single-output ignition coil12V coil with 5-ohm primary resistance, attached leads and approximately 80mm mounting centers. Sold individually.Voir la pièce
Ignition condenserReplacement condenser with reference 30280-292-672, matching the K3 factory condenser reference.Voir la pièce
Round-plug ignition switchSix-hole, four-wire round connector for the early harness. Confirm the connector on your motorcycle before ordering.Voir la pièce
Pièces connexes : Left contact breaker · Right contact breaker · LB05F spark plug cap
The 5-ohm replacement coil has a 19-inch plug lead and approximately 80mm mounting centers. Its attached primary leads use bullet connectors. When replacing a beige Honda coil, the supplier specifies the reverse mounting orientation because the wires leave the housing differently; compare lead clearance before ordering.
Honda identifies separate right and left breakers for the K3, matching references 30203-286-004 and 30204-286-004. The linked replacements are separate products rather than a combined pair. The featured condenser references 30280-292-672. Use the service manual for inspection, adjustment and ignition timing.
Only if that harness accepts the specified round six-hole, four-wire connector and the connections are appropriate. Compare the actual plug before ordering. The product’s early-CB350 application does not establish compatibility with a changed or aftermarket loom.
The featured single-output coil is sold individually. Order the number your repair requires after identifying which coil or coils need replacement. Check mounting centers, attached leads and the ignition system’s resistance requirement before choosing the quantity.
Check the electronic-ignition manufacturer’s required primary resistance first. The featured replacement coil is 5 ohms; the separate performance option has a different resistance. A shared model application does not make those coils interchangeable for every conversion.
Envoyez-nous le modèle et l’année de votre moto, des photos de la pièce actuelle et les détails de toute modification par rapport au montage d’origine.
Sélectionnez le modèle exact et l’année pour affiner les résultats.
Choisissez votre modèle et l’année.