Pièces pour motos Honda
Choisissez votre modèle et l’année pour voir les pièces répertoriées pour votre moto.
Choisissez votre modèle et l’année pour voir les pièces répertoriées pour votre moto.
1972 Honda CB500K · Fuel & Intake Buying guide
One-carb kits address internal service, a stock-type filter fits the compatible airbox, and cap hardware deals with the tank. Check the installed carburetors and airbox before ordering; a custom intake setup changes the comparisons needed for filters and rack support.
Rebuild kit for one CB500K carburetorListed gaskets, jets, needle-and-seat parts and small hardware for one carburetor.Voir la pièce
Original-airbox replacement filterOne filter serves the compatible stock airbox; reference 17210-323-030.Voir la pièce
Chrome replacement fuel capReference 17510-323-310; gasket and hinge hardware are expressly included.Voir la pièce
Pièces connexes : Four engine-side rubber holders · Replacement carb float and pin
The rebuild source lists the supplied internal parts and specifies one kit per carburetor. Compare the list with the actual repair rather than assuming floats, intake holders or rack hardware are included. The float is a separate individual product, while the holder set supplies all four holders.
An intact compatible stock airbox uses the listed replacement element. Pods use a measured carburetor inlet and require their own clearance and support checks. Inspect the airbox boots and holders before deciding which arrangement to retain; do not combine parts for different setups merely from a shared model name.
The kit names bowl and top gaskets, a 1.8 needle-and-seat, jets, D26 needle, O-rings, screw with spring and C-clip. One kit services one carburetor. Compare that list before adding separate valves or gaskets; floats and intake holders are not named contents.
The filter references 17210-323-030 for the original 1971–73 CB500K airbox, with one supplied and one required. Confirm the airbox is still present. A removed or replaced airbox requires its own intake fitment check before applying that original-filter specification.
The chrome cap supplies its gasket, hinge pin and E-clip under reference 17510-323-310. The separately offered latch has its own return spring, mounting pin and C-clip. Inspect the retained cap and latch before adding overlapping sealing or hinge parts.
Envoyez-nous le modèle et l’année de votre moto, des photos de la pièce actuelle et les détails de toute modification par rapport au montage d’origine.
Sélectionnez le modèle exact et l’année pour affiner les résultats.
Choisissez votre modèle et l’année.