Pièces pour motos Honda
Choisissez votre modèle et l’année pour voir les pièces répertoriées pour votre moto.
Choisissez votre modèle et l’année pour voir les pièces répertoriées pour votre moto.
1971 Honda CB500K · Fuel System Buying guide
Separate tank hardware, carburetor internals and intake rubber before assembling an order. Stock-airbox parts and clamp-on filter options represent different setups, while a carburetor service kit addresses one carburetor rather than the complete four-carb bank.
CB500K carburetor rebuild kitJapanese-made kit for one carburetor; four kits service the complete listed rack.Voir la pièce
Stock-type CB500K air filterAirbox filter element replacing Honda reference 17210-323-030.Voir la pièce
Chrome fuel tank capOEM-type cap supplied with gasket, hinge pin and E-clip.Voir la pièce
Pièces connexes : Four-piece carb holder set · Individual carb float with pin
One rebuild kit services one CB500K carburetor. Its stated contents include gaskets, needle-and-seat parts, jets, a jet needle and small hardware; four kits are required for the complete rack. A new float is a separate listing, so do not assume every worn carburetor component is included.
The stock-type filter is selected for an intact compatible airbox. Clamp-on filters require a confirmed inlet diameter and appropriate rack support. Check the airbox boots and engine-side holders separately; the four-piece sets are different parts and use different clamp specifications.
One kit contains bowl and top gaskets, a 1.8 needle-and-seat, jets, D26 jet needle, O-rings, screw with spring and C-clip. It services one carburetor. Floats and engine-side holders are not named contents; four kits cover the complete rack.
The engine-side holder set supplies four holders, referencing 16211-323-000, with eight separate 41–44 mm clamps required when needed. The airbox boot set supplies four boots using four 45–47 mm clamps. Identify the retained intake joint before choosing either package.
The cap references 17510-323-310 and includes a gasket, hinge pin and E-clip. The latch assembly separately names a chrome latch, return spring, mounting pin and C-clip. Compare the retained latch so a cap order does not duplicate needed hardware.
Envoyez-nous le modèle et l’année de votre moto, des photos de la pièce actuelle et les détails de toute modification par rapport au montage d’origine.
Sélectionnez le modèle exact et l’année pour affiner les résultats.
Choisissez votre modèle et l’année.