Honda motorcycle parts
Choose your model and year to see parts listed for your bike.
Choose your model and year to see parts listed for your bike.
1974 Honda CB450K · Electrical Buying guide
The headlight plug gives a Honda reference; the coil lists primary resistance, mounting spacing and wire lengths. Starter brushes specify the motor design and supplied pair. Charging controls have battery restrictions that remain separate from lamp, ignition and starter-component compatibility.
Headlight plug under its Honda referenceOEM-style lamp plug referencing 33130-300-003 for the stated CB450K application. Compare the retained lamp termination and wiring interface. The description does not supply complete terminal dimensions or identify this as an entire wiring-harness replacement.View part
Coil with documented primary and lead detailsIndividually sold 12V single-output coil, 5-ohm primary, approximately 80mm mounting centres and attached wires. The plug lead is 19 inches. Compare all connector paths and the reversed-mounting instruction when replacing a beige Honda coil.View part
Specified pair for a Mitsuba starterSet of two 12 × 14 × 6mm brushes for Mitsuba two-brush starters, with one insulated and one non-insulated lead arrangement. References 31201-292-158 / 31201-MG9-004. Match the motor and removed brushes before selecting the pair.View part
Related parts: Headlight package and retained mounting-bolt checks · Front stop-switch thread and connection details · Lithium charging-control voltage requirement
The stock-style headlight package lists lamp, case, trim and wiring/hardware, but its CB450K instruction requires old headlight mounting bolts. Compare the retained supports and those fasteners before choosing it. A plug-only repair has its own electrical interface and does not identify the wider structural repair.
Lithium Hot Shot controls specify 14V ±0.2, subject to confirmation for the battery, and exclude standard lead-acid batteries. Standard versions are for lead-acid only. Identify the battery actually installed and choose a consistent control or rotor-kit version for that requirement.
Identify its electrical termination and mounting separately. The OEM-style plug lists 33130-300-003 without a full terminal drawing, while the stock-style lamp assembly has a specific CB450K bolt-reuse requirement. Confirm the missing details needed by the lamp and supports now fitted.
The coil is sold individually with wires attached; plug caps are separate individually sold choices. Identify the connections and electrical requirements of the ignition being retained. The coil description does not itemize a supplied cap, and neither cap listing states its resistance value.
Establish the motor design, removed brush dimensions and insulated/non-insulated lead arrangements. The offered pair is specified for Mitsuba two-brush motors at 12 × 14 × 6mm. Confirm that identification before using the motorcycle application to select internal motor parts.
Send your model and year, plus photos of your existing part and any changes to the original setup.
Select your exact model and year to narrow your results.
Choose your model and year.