My motorcycle Choose your Honda CB model

Search parts

Searching all Honda CB parts

Example: brake pads or oil filter.

Currently viewing Turn Signal Lamps, Stems, Lenses & Reflectors

Honda motorcycle parts

Choose your model and year to see parts listed for your bike.

Honda CB Stock Type Reflector ~ Replaces 33741-340-670

$21.46 USD
11-2303
Restore your mid-'70s Honda's stock reflectors with this Stock-Type Screw-On Reflector with a 6mm thread, replacing OEM #33741-340-670. Broad fitment covering the 1972-78 CB750...
New
Honda CB750 CB550 CB500 CB400 headlight stay headlight reflector bolt 90120-377-000

Honda CB750 / CB550 / CB500 / CB400 Headlight Stay / Headlight Reflector Bolt ~ Replaces 90120-377-000

$8.95 USD
99-4977
Upgrade or restore your classic Honda motorcycle headlight system with this Headlight Stay / Headlight Reflector Bolt — designed to secure the headlight reflector...
New
Honda CB750 CB550 CB500 headlight reflector rubber base 33743-375-000

Honda CB750 / CB550 / CB500 Headlight Reflector Rubber Base ~ Replaces 33743-375-000

$12.95 USD
99-4976
Replacement rubber base for restoring your CB750's headlight assembly back to proper condition. This is the rubber mount that the headlight reflector attaches to...

Honda CB Turn Signal Lamp Gasket ~ Replaces 33406-377-671

$4.61 USD
11-2084
Replace the gasket on your turn signal with this Turn Signal Lamp Gasket, replacing OEM #33406-377-671. Pairs with our signal lamps #11-2114 and #11-2149...

Honda CB Turn Signal Lamp Lens Screw Set ~ Replaces 93500-04025-0A

$2.95 USD
73-1034
Replace your turn signal lens screws with this Turn Signal Lamp Lens Screw Set of 2, replacing OEM #93500-04025-0A.Note: also fits our signal lens...

1977 Honda CB550F · Signals & Reflectors Buying guide

Check the housing before choosing signal repair parts

Gaskets and lens screws serve the matching stock-style signal housing. A screw-on reflector has a separate 6 mm mounting requirement; its fit is not determined by the signal lens profile or electrical connection.

Match the seal to the lens and housing together

The gasket is listed for the matching stock-style front and rear housings and amber lens. The separate retaining set supplies two screws. Compare the old lens joint and screw positions before ordering them for custom signals, which may use different seals and fasteners.

Treat lamp wiring and reflector mounting as separate checks

The stock-style front lamp is described as 12 volt with two wires; the rear as 12 volt with one wire. Compare the installed connections and mount rather than inferring a wiring arrangement from the lens colour. The reflector requires its own 6 mm screw-on fitting.

Buying questions

Can the stock-style gasket seal a custom signal housing?

Only choose it after comparing the custom housing and lens profile with the matched stock-style application. Model-year fitment does not establish interchange with every aftermarket lamp. Check the retaining screw positions at the same time.

Does one lens-screw set contain two screws?

Yes, the set is supplied as a pair of screws for the matching signal housing. Inspect the screw positions and threads on the fitted lamp before choosing the set for a changed housing.

Will the reflector fit wherever the signal lamp mounts?

The reflector is a separate screw-on part with a 6 mm thread. Compare that fitting with the intended mounting point. The lamp’s stem, wiring and housing do not establish the correct reflector connection.

Not sure which part you need?

Send your model and year, plus photos of your existing part and any changes to the original setup.

Ask a fitment question

Your cart

×