Pièces pour motos Honda
Choisissez votre modèle et l’année pour voir les pièces répertoriées pour votre moto.
Choisissez votre modèle et l’année pour voir les pièces répertoriées pour votre moto.
1970 Honda SL350K0 · Ignition Parts Buying guide
The replacement switch uses a round six-hole, four-wire plug. Separate left and right contact points are available, while the linked single-output coil has its own resistance, lead and mounting specifications to compare.
Round-plug ignition switchRound six-hole, four-wire connector; match the harness connector before ordering.Voir la pièce
Left-side contact pointLeft-side contact point; replacement references 30204-286-004 and 30202-369-154.Voir la pièce
Right-side contact pointRight-side contact point; replacement references 30203-286-004 and 30203-369-154.Voir la pièce
Pièces connexes : Ignition condenser · Single-output 5-ohm ignition coil
The left point uses references 30204-286-004 and 30202-369-154; the right point uses 30203-286-004 and 30203-369-154. Record which side you need before ordering. The separately linked condenser is another component, so do not infer a full ignition-service kit from either point entry.
The linked 5-ohm coil is a 12 V single-output unit, sold individually, with approximately 80 mm mounting centers and a 19-inch plug lead. It has a 6.5-inch blue lead with dual female bullets and a 5.25-inch black/white lead with a male bullet. Compare the actual ignition’s resistance requirement and connections.
They are separate entries with distinct replacement references. The left point starts with 30204-286-004 and the right with 30203-286-004. Identify the side being repaired rather than ordering two identical pieces on appearance alone.
Check the ignition’s required primary resistance, approximately 80 mm mounting centers and attached lead connections. The linked coil is 12 V and 5 ohms. The separate 3.3-ohm coil is another choice, so an electronic conversion must follow its manufacturer’s coil requirement.
A round housing is only one detail. This switch has a six-hole, four-wire plug. Compare terminal locations and the circuit connections with the fitted loom before ordering, using the correct wiring information for any conversion.
Envoyez-nous le modèle et l’année de votre moto, des photos de la pièce actuelle et les détails de toute modification par rapport au montage d’origine.
Sélectionnez le modèle exact et l’année pour affiner les résultats.
Choisissez votre modèle et l’année.