VintageCB750, au service des motocyclistes CB depuis 2010

À propos Pourquoi nous choisir? Avis clients Livraison Retours Nous joindre
Favoris
0 Panier

Votre panier est vide.

Parcourir toutes les pièces
Total (USD): $0.00
Voir le panier
Menu
Rechercher
Favoris
Panier 0
Ma moto Choisissez votre modèle Honda CB

Rechercher des pièces

Recherche dans toutes les pièces Honda CB

Exemple : oil filter (filtre à huile) ou une référence OEM.

1982 Honda CB450SC Nighthawk — Clignotants, supports, cabochons et réflecteurs

Rear signal mounting service on your 1982 CB450SC Nighthawk starts with the rubber beneath each stay. The current 33606-371-000 replacement is supplied as a two-piece pack. Count the signals needing attention and inspect the retained mounting pieces before deciding what belongs in the order.

Fermer ×
Votre moto enregistrée Choisissez votre modèle Honda CB

Magasiner par catégorie

La plupart des commandes sont expédiées le jour ouvrable même ou le suivant Garantie de compatibilité Pièce répertoriée pour votre modèle et votre année? Si elle ne convient pas comme indiqué, nous trouverons une solution. Soutien technique Demandez à notre équipe de vous aider à choisir la bonne pièce Honda CB.
Consultation en cours Clignotants, supports, cabochons et réflecteurs

Pièces pour motos Honda

Choisissez votre modèle et l’année pour voir les pièces répertoriées pour votre moto.

Honda CB750 CB500 CB450 CB400 turn signal lamp gasket 33443-268-671

Honda CB Turn Signal Lamp Gasket ~ Replaces 33443-268-671

$4.61 USD
11-2085
Service your early CB750 or classic twin turn signal with this Turn Signal Lamp Gasket, replacing OEM #33443-268-671. Pairs with our signal lens #11-2110...
Honda CB750 CB550 CB450 CB400 rear turn signal rubbers pk 2 33606-371-000

Honda CB750 / CB550 / CB450 / CB400 Rear Turn Signal Rubbers Pk/2 ~ Replaces 33606-371-000

$15.95 USD
73-0834
Replace your rear turn signal rubbers with this Rear Turn Signal Rubbers Pk/2, replacing OEM #33606-371-000. These are the rubbers that go under the...
Comparer

1982 Honda CB450SC Nighthawk · Turn Signal Lamps, Stems, Lenses & Reflectors Buying guide

Allow two rubbers for each rear signal stay

Part 73-0834 contains two rubbers, and each rear signal uses two. One pack therefore services one rear signal mount. These pieces cushion the stay at its mounting bracket; the condition of that stay and its hardware remains a separate part of the repair decision.

Parts to consider

Honda CB750 / CB550 / CB450 / CB400 Rear Turn Signal Rubbers Pk/2 ~ Replaces 33606-371-000 One pack for one rear signal mountTwo 33606-371-000 replacement rubbers are supplied. The listed 1982 CB450SC application requires two per rear signal, so both sides take two packs.Voir la pièce

Count complete mounts rather than loose rubber pieces

The pack quantity and installed quantity happen to match for one rear signal: two rubbers in the pack and two at the stay. A two-sided repair needs four rubbers, supplied as two packs. Counting the mounts first makes the order clear and avoids treating a pack of two as enough for both sides.

Look beyond the rubber when the stay needs attention

The source calls for checking the stay, mounting bracket, collars, washers and fasteners when a signal droops or vibrates. Rubber renewal may be one part of that work. Compare the original mounting arrangement, particularly on a modified bike, without assuming new rubbers correct a bent stay or missing hardware.

Rear Signal Mount Rubbers FAQs

Does one pack renew the mounting rubbers on both rear signals?

One pack supplies two rubbers, and each rear signal uses two. Renewing both rear stays takes two packs, or four rubbers in total. Count one complete rear signal mount per pack when preparing the order.

Which retained parts should I inspect if a rear signal droops?

Inspect the stay, mounting bracket, collars, washers and fasteners, as the product FAQ recommends. Check for bent or missing pieces before ordering. The rubbers cushion the stay, but a damaged mounting part can need attention alongside them.

How do I choose these rubbers for a bike with changed rear signals?

Match reference 33606-371-000 and the stay-to-bracket arrangement actually fitted. The source lists the stock CB450SC application and two rubbers per rear signal. It does not establish compatibility with every replacement stay or custom mounting design.

Vous ne savez pas quelle pièce choisir ?

Envoyez-nous le modèle et l’année de votre moto, des photos de la pièce actuelle et les détails de toute modification par rapport au montage d’origine.

Poser une question sur la compatibilité
Catégories de pièces pour 1982 Honda CB450SC Nighthawk

Votre panier

×