VintageCB750, au service des motocyclistes CB depuis 2010

À propos Pourquoi nous choisir? Avis clients Livraison Retours Nous joindre
Favoris
0 Panier

Votre panier est vide.

Parcourir toutes les pièces
Total (USD): $0.00
Voir le panier
Menu
Rechercher
Favoris
Panier 0
Ma moto Choisissez votre modèle Honda CB

Rechercher des pièces

Recherche dans toutes les pièces Honda CB

Exemple : oil filter (filtre à huile) ou une référence OEM.

1982 Honda CB450SC Nighthawk — Câbles

For the 1982 CB450SC Nighthawk, begin a speedometer cable job by checking the existing drive and instrument. The listed replacement has a specific Honda reference; the separate gear plug serves only an original drive opening that is being left unused.

Fermer ×
Votre moto enregistrée Choisissez votre modèle Honda CB

Magasiner par catégorie

La plupart des commandes sont expédiées le jour ouvrable même ou le suivant Garantie de compatibilité Pièce répertoriée pour votre modèle et votre année? Si elle ne convient pas comme indiqué, nous trouverons une solution. Soutien technique Demandez à notre équipe de vous aider à choisir la bonne pièce Honda CB.
Consultation en cours Câbles

Pièces pour motos Honda

Choisissez votre modèle et l’année pour voir les pièces répertoriées pour votre moto.

Honda CB1000 CB900 CB750 CB650 speedo gear plug

Honda CB1000/CB900/CB750/CB650 Speedo Gear Plug

$43.95 USD
29-0538
Keep your speedo drive gear clean with this Speedo Gear Plug, 15mm outer diameter, 22mm long.Key Features• Speedo gear plug• 15mm outer diameter, 22mm...
Épuisé
Honda CB750C CB650C CB450SC speedometer cable 44830-MA5-670

1981-82 Honda CB750C / CB650C / CB450SC Speedometer Cable ~ Replaces 44830-MA5-670

$23.45 USD
73-0199
Replace your CB Custom or CB450SC speedometer cable with this Speedometer Cable, replacing OEM #44830-MA5-670. Made in Japan.Key Features• Speedometer cable• Replaces OEM #44830-MA5-670•...
Comparer

1982 Honda CB450SC Nighthawk · Cables Buying guide

Plan the cable route or close an unused drive opening

The replacement cable cites Honda 44830-MA5-670 and explicitly lists the 1982 Nighthawk. Its current information does not give an overall length. The gear plug is a different option for a removed cable: one approximately 15mm-OD, 22mm-long plug for the retained original wheel-drive opening.

Parts to consider

1981-82 Honda CB750C / CB650C / CB450SC Speedometer Cable ~ Replaces 44830-MA5-670 Japanese-made replacement cableReplaces Honda reference 44830-MA5-670 for the listed 1982 CB450SC Nighthawk. One cable is included; the current source does not specify its overall length.Voir la pièce Honda CB1000/CB900/CB750/CB650 Speedo Gear Plug Original speedometer-drive plugOne plug, approximately 15mm outer diameter and 22mm long, for the original front-wheel drive opening when the cable is removed. Check secure retention and clearance after fitting.Voir la pièce

Investigate the drive as well as the cable

The cable’s instructions call for inspection of the gauge and its drive unit for wear. Seat both ends fully and avoid a route that creates sharp bends or tension. Follow the cable maker’s lubrication instructions rather than assuming a new cable resolves a binding component.

Measure a changed cable route

The listed replacement application is specific, but no cable length is given. A relocated instrument or taller bar needs a comparison with the required routing length and end connections; ask for the cable dimensions before relying on the original application.

Common ordering questions

Does this cable suit a taller handlebar or relocated instrument?

The listing confirms the standard 1982 CB450SC application and reference 44830-MA5-670, but gives no overall cable length. Compare the required route and end connections, then request dimensions before ordering for a changed bar or instrument position.

What should I check if a replacement cable leaves the speedometer noisy?

Check wear or binding in the gauge and drive unit, full seating at both cable ends, and a route free of sharp bends or tension. The current cable instructions make clear that it cannot repair a worn instrument or drive.

How should an unused wheel-drive opening be closed?

The listed plug is supplied as one piece, approximately 15mm OD by 22mm long, for the original opening after cable removal. Check secure seating and retention, and confirm clearance from the wheel, fork, axle and drive gear.

Vous ne savez pas quelle pièce choisir ?

Envoyez-nous le modèle et l’année de votre moto, des photos de la pièce actuelle et les détails de toute modification par rapport au montage d’origine.

Poser une question sur la compatibilité
Catégories de pièces pour 1982 Honda CB450SC Nighthawk

Votre panier

×