Pièces pour motos Honda
Choisissez votre modèle et l’année pour voir les pièces répertoriées pour votre moto.
Choisissez votre modèle et l’année pour voir les pièces répertoriées pour votre moto.
1968 Honda CB450K · Electrical Buying guide
A matching ignition connector, suitable coil mounting and a compatible battery are different requirements. Use each product’s own specifications to narrow the order; one shared motorcycle application does not make every electrical option interchangeable.
Round-plug ignition switchRound six-hole, four-wire switch listed for the 1968 CB450K with a round harness connector. References include Honda 35100-292-003. Compare the plug and fitted switch before ordering.Voir la pièce
12V coil with attached wiringA single-output coil with 5-ohm primary resistance and attached wires, including a 19-inch spark plug lead. Compare approximately 80 mm mounting-hole centres with your bracket. Sold individually; order the quantity required.Voir la pièce
Lead-acid Hot Shot rectifier/regulatorRick’s combination unit listed for standard lead-acid batteries and the existing stator. It is expressly unsuitable for lithium-ion batteries. Compare the fitted charging system and connector before selection.Voir la pièce
Pièces connexes : Rear brake light switch · Mitsuba two-brush starter service set · Genuine Honda rear signal stay
The ignition and charging listings offer replacements with different connection requirements. Inspect the existing assembly before adding supporting parts. A rear signal stay, starter terminal boot and motor brush set each service a different part of the electrical installation; compare the actual component being renewed.
The standard Hot Shot unit is for lead-acid batteries. Its lithium-compatible alternative gives a 14V ±0.2 set point and excludes standard lead-acid batteries. Confirm your battery manufacturer’s requirements before selecting the lithium version, particularly where previous work has changed the charging system.
The switch is specified for a round six-hole, four-wire connector. Compare the actual harness plug and switch on your motorcycle. A different connector or an altered harness needs clarification before you treat the listed model application as a direct match.
The brush set specifically describes a Mitsuba two-brush starter and gives dimensions of 12 × 14 × 6 mm. It supplies one insulated-lead and one non-insulated-lead brush. Compare the fitted starter and removed brushes before assuming a replacement starter uses the same set.
Its listing explicitly excludes standard lead-acid batteries. The standard Hot Shot unit has the opposite lithium exclusion. Identify your battery type first, then check the chosen unit’s requirements and any stated voltage set point against the battery manufacturer’s guidance.
Envoyez-nous le modèle et l’année de votre moto, des photos de la pièce actuelle et les détails de toute modification par rapport au montage d’origine.
Sélectionnez le modèle exact et l’année pour affiner les résultats.
Choisissez votre modèle et l’année.