My motorcycle Choose your Honda CB model

Search parts

Searching all Honda CB parts

Example: brake pads or oil filter.

Currently viewing Fork Tubes, Springs, Seals & Boots

Honda motorcycle parts

Choose your model and year to see parts listed for your bike.

Honda CB Stock Type Reflector ~ Replaces 33741-340-670

$21.46 USD
11-2303
Restore your mid-'70s Honda's stock reflectors with this Stock-Type Screw-On Reflector with a 6mm thread, replacing OEM #33741-340-670. Broad fitment covering the 1972-78 CB750...

Honda CB Stock Type Front Reflector Rubber Base ~ Replaces 33743-341-670

$8.95 USD
11-2304
Fit the rubber base beneath your stock front reflector with this Stock-Type Front Reflector Rubber Base, replacing OEM #33743-341-670.Key Features• Stock-type front reflector rubber...

1973-74 Honda CB350F Fork Seals

$18.76 USD
27-1011
Replace your CB350F Supersport fork seals with this Fork Seal Set, 33 x 46 x 11 / 10.5mm. Made in Japan by OEM supplier.Key...

1973 Honda CB350F0 · Fork Seals & Reflector Mounts Buying guide

Identify the fork before choosing its seals

The available seal set specifically lists the 1973–74 CB350F and gives a 33 × 46 × 11 / 10.5mm size. Check the installed assembly before ordering, especially after a front-end swap.

Use the seal dimensions carefully

The seal set is Japanese-made and lists a 33 × 46 × 11 / 10.5mm size. Use that as the replacement’s dimensional specification, then compare it with the installed fork. A motorcycle’s model year alone does not identify forks changed during an earlier rebuild.

Inspect the surrounding parts

Check the fork tubes for damage and follow the correct service manual for disassembly, fluid and installation details. The front reflector rubber base is a separate body fitting at the fork area; replace it for its own wear rather than treating it as part of the seal kit.

Fork Seals & Reflector Mounts questions

Does this seal set include the 1973 CB350F?

Yes. Its application specifically covers the 1973–74 CB350F. Compare the 33 × 46 × 11 / 10.5mm specification with the seals and fork assembly actually installed before ordering.

Can I select seals by fork-tube diameter alone?

Check the complete seal dimensions and fork application, not only the tube diameter. A seal must match the relevant housing and height as well, particularly when replacement forks are fitted.

Should damaged fork tubes be checked before new seals?

Yes. Inspect the tube surfaces and other relevant fork components while diagnosing leakage. Follow the service manual for the repair; replacing seals alone may not address damage elsewhere in the assembly.

Not sure which part you need?

Send your model and year, plus photos of your existing part and any changes to the original setup.

Ask a fitment question

Your cart

×