Honda motorcycle parts
Choose your model and year to see parts listed for your bike.
Choose your model and year to see parts listed for your bike.
1982 Honda CB450SC Nighthawk · Electrical Buying guide
A shared model application does not make every electrical replacement interchangeable. Connector layout distinguishes the charging units, while the starter circuit has its own switch, diode and terminal protection. Keep those decisions separate from the condition of plug caps and signal mounts.
Six-wire charging replacementPart 24-2088 has three yellow wires in one connector block and three wires in a four-space block. Its Honda references include 31600-MC9-740.View part
Starter terminal coverOne rubber boot cross-references 32411-230-000 and protects the high-current starter connection. The cable and terminal nut are separate.View part
Clutch-lever starter safety switchReference 35330-413-003 identifies the clutch safety switch. The description and FAQs establish starter-interlock operation despite brake-light wording in the product title.View part
Related parts: Individual XD05F plug cap · Rear signal mounting rubbers · Starter safety-circuit diode
A plug-cap replacement and starter-terminal repair call for different supporting parts. The XD05F cap excludes the high-tension wire; the terminal boot excludes the cable and nut. The rear signal rubbers come as a two-piece pack that services one rear signal, so count the mounts needing attention.
The clutch-lever switch and starter diode both concern the starter safety circuit, but they are separate components. The diode is not the main charging rectifier. Use the switch reference and the diode references to identify the needed part, and preserve the motorcycle’s safety circuit when planning the work.
Compare both connectors: part 24-2088 uses three yellow wires in one block and three wires in a four-space block. Also match the Honda reference; the listed replacements include 31600-KV8-681, 31600-413-008 and 31600-MC9-740.
Choose by reference 35330-413-003 and the clutch-lever position. Its description and FAQs identify starter safety operation, despite brake-light wording in the title. The rear brake-light switch is a separate component for the rear-brake control.
Each rear signal uses two 33606-371-000 rubbers, and one pack contains two. Order two packs when renewing both rear signal mounts. Inspect the stays, brackets and retained mounting hardware before deciding whether rubber replacement addresses the whole repair.
Send your model and year, plus photos of your existing part and any changes to the original setup.
Select your exact model and year to narrow your results.
Choose your model and year.