My motorcycle Choose your Honda CB model

Search parts

Searching all Honda CB parts

Example: brake pads or oil filter.

Currently viewing Handlebar Switches

Honda motorcycle parts

Choose your model and year to see parts listed for your bike.

Honda CB900 / CB750 / CB650 Bar Switch Assembly ~ Left (Clutch) Side ~ Replaces 35200-460-671

$109.95 USD
12-0309
Restore proper left-side controls on your DOHC CB with this Bar Switch Assembly for the Clutch Side in black. A direct replacement for OEM...

Honda CB900 / CB750 / CB650 Bar Switch Assembly ~ Right (Brake) Side ~ Replaces 35130-461-770

$79.95 USD
12-0303
Fit the right-side handlebar controls on your DOHC CB with this Bar Switch Assembly for the Brake Side in black, replacing OEM #35130-461-770 /...

1982 Honda CB750K · Handlebar Switches Buying guide

Keep left and right control assemblies distinct

The left assembly is the clutch-side control and the right assembly is the brake-side control. Compare the connector arrangement and wire path for that specific side rather than ordering by appearance alone.

Match each side before checking connectors

Start with the correct left or right assembly, then compare the connectors and housing arrangement with the motorcycle. The left listing describes turn-signal, horn and lighting controls. Confirm the specific functions in the product instructions rather than assuming the two sides have equivalent wiring.

Inspect the external wiring path

Both featured assemblies specify wiring outside the handlebar. If the bike has been rewired or fitted with different bars, inspect the existing path and available reach. Follow the wiring diagram and supplied instructions when checking connections; matching wire colour alone is not a complete identification.

Common questions

Which assembly belongs on the clutch side?

The left-side switch assembly is listed for the clutch side. Compare its controls, mounting and connector arrangement with the actual motorcycle before ordering, especially where the bars or wiring have changed.

Does the wiring run inside the handlebars?

The descriptions for both featured assemblies state that the wiring runs outside the handlebar. Check the intended path and available movement rather than assuming these are internal-wire switch replacements.

Can the connector be identified by colour alone?

Compare the connector layout, circuit identification and product instructions as well as wire colours. Previous repairs may have changed the wiring, so verify the connections against the motorcycle diagram before installation.

Not sure which part you need?

Send your model and year, plus photos of your existing part and any changes to the original setup.

Ask a fitment question

Your cart

×