Honda motorcycle parts
Choose your model and year to see parts listed for your bike.
Choose your model and year to see parts listed for your bike.
1977 Honda CB750K · Starter & Charging Buying guide
A four-brush replacement motor, a roller-and-spring clutch kit and a stock-style stator serve separate repair needs. Diagnose the fault first so a starting symptom does not lead to an unrelated charging-system order.
Four-brush replacement starter motorRick’s Electric replacement for 31200-300-030, using a four-brush permanent-magnet design and supplied with a battery cable.View part
Starter-clutch roller, cap and spring kitThree rollers listed at 15 × 13 mm, three caps at 15.5 × 6.2 mm and three springs; the listing does not label the dimension axes.View part
Stock-style replacement statorReplacement stator listed for the SOHC CB750K and CB750F, with multiple stated Honda reference numbers.View part
Related parts: Solenoid: 35850-375-000 / 35850-286-027 · Mitsuba two-brush starter service set · Stator harness with seven-wire plug
The stator harness replaces 31110-300-154 and lists a seven-wire plug. The stator itself lists separate replacement references. Compare the damaged component and connector before ordering an entire stator for an identified lead repair.
A regulator’s battery requirement does not settle its mounting fit. Compare the intended battery chemistry, installed charging equipment and space for the exact unit. Retain the correct safety functions and use the manufacturer’s installation instructions.
Part 24-2109 lists 68 mm length, 94 mm width and 26 mm height, with mounting holes 80 mm centre to centre. It includes stock-type plugs and instructions but warns that custom mounting may be needed. Compare that envelope and hole spacing before treating matching plugs as a complete bolt-on fit.
The set replaces 31201-292-158 and 31201-MG9-004 and lists 12 × 14 × 6 mm brushes, one with insulated leads and one with non-insulated leads, for a Mitsuba two-brush motor. Match the motor and removed brushes; these contents do not establish service compatibility with the featured four-brush replacement.
Part 24-2011 is for lithium-ion batteries only, excludes standard lead-acid batteries and lists a 14 V ±0.2 set point. Confirm that value with the battery manufacturer; lithium compatibility in a title alone is not enough. Its 70 × 94 × 27 mm body and 80 mm hole spacing also need a separate mounting check.
Send your model and year, plus photos of your existing part and any changes to the original setup.
Select your exact model and year to narrow your results.
Choose your model and year.