My motorcycle Choose your Honda CB model

Search parts

Searching all Honda CB parts

Example: brake pads or oil filter.

Currently viewing Handlebar Switches

Honda motorcycle parts

Choose your model and year to see parts listed for your bike.

Honda CB750 / CB550 / CB400 Bar Switch Assembly ~ Right (Brake) Side ~ Replaces 35300-341-671

$74.95 USD
12-0301
Rebuild your right-side handlebar controls with this Bar Switch Assembly for the Brake Side in black, replacing OEM #35300-341-671. Wiring runs outside the handlebar....

Honda CB750 / CB550 / CB400 Bar Switch Assembly ~ Left (Clutch) Side ~ Replaces 35200-374-671

$74.95 USD
12-0300
Rebuild your left-side handlebar controls with this Bar Switch Assembly for the Clutch Side in black, replacing OEM #35200-374-671 / #35200-390-671. Note that wiring...

1974 Honda CB750K · Handlebar Switches Buying guide

Choose the correct side and wire route

These two assemblies are side-specific. Match the controls and wiring arrangement before ordering, with extra attention to altered handlebars or connectors from an earlier repair or custom conversion.

The wire routes differ between sides

The left assembly listing specifies wiring inside the handlebar, while the right assembly’s wiring runs outside it. This matters when the bike has replacement bars or changed controls. Compare the current arrangement carefully and consult the product instructions before deciding that either assembly suits a modified setup.

Keep the model year in the comparison

The right assembly is listed as a direct fit for the 1973–75 CB750K, including this 1974 model. Later-year notes describe control differences, so use the correct year-specific information. Compare the actual harness and switch functions too, since previous changes may have altered the original configuration.

Common questions

Can I use the same assembly on either side?

No. The left listing is for the clutch side and the right listing is for the brake side. Their controls and wire routes differ, so select the specific assembly for the side needing attention.

Do both assemblies route their wires outside the handlebars?

No. The product descriptions specify internal routing for the left assembly and external routing for the right. Check that your existing or replacement handlebars support the arrangement required by the chosen assembly.

What if my 1974 bike has custom handlebars?

Compare the bars, existing switch mounting and available wire route before buying. The model-year listing describes the assembly’s application, but altered bars or connectors need an additional compatibility check using the product instructions and photos of your setup.

Not sure which part you need?

Send your model and year, plus photos of your existing part and any changes to the original setup.

Ask a fitment question

Your cart

×