Pièces pour motos Honda
Choisissez votre modèle et l’année pour voir les pièces répertoriées pour votre moto.
Choisissez votre modèle et l’année pour voir les pièces répertoriées pour votre moto.
1967 Honda CL450K0 · Electrical Parts Buying guide
The useful distinctions here are physical and electrical: switch connector layout, coil resistance and spacing, or starter construction. A shared motorcycle application does not remove the need to identify equipment changed during earlier repairs.
Single-output ignition coil12V coil with 5-ohm primary resistance, attached leads and approximately 80mm mounting centers; sold each.Voir la pièce
Round-plug ignition switchRound connector with six holes and four wires; compare the fitted harness before choosing.Voir la pièce
Female-connector rectifierSeparate rectifier with a female connector and replacement reference 31700-292-008 among its listed references.Voir la pièce
Pièces connexes : Mitsuba two-brush service set · Rear brake-light switch · Front stop-switch cable clip
The featured coil is supplied individually with its leads attached. Its approximately 80mm mounting centers and 19-inch plug wire are product measurements, useful when comparing a replacement bracket or rerouted wiring. Count the units being replaced rather than assuming one order supplies an ignition system.
The related front cable clip holds stop-switch wires against the front cable. Choose it when that support is missing or damaged. For a starter-motor repair, the related brush set instead requires a Mitsuba two-brush motor and comparison of brush dimensions and lead insulation.
This replacement uses four wires in a six-hole round connector. Compare the connector housing and occupied positions with your harness; the hole count alone does not establish the correct electrical connections.
Also compare the 12V, 5-ohm specification, attached lead arrangement and plug-wire reach with your ignition equipment. A previous electronic conversion needs its own compatibility check, even when the mounting centers appear suitable.
The related brush set is for Mitsuba two-brush starters, with 12 × 14 × 6mm brushes and different insulated and non-insulated leads. Identify a replacement motor before treating the motorcycle model as sufficient evidence.
Envoyez-nous le modèle et l’année de votre moto, des photos de la pièce actuelle et les détails de toute modification par rapport au montage d’origine.
Sélectionnez le modèle exact et l’année pour affiner les résultats.
Choisissez votre modèle et l’année.