Ma moto Choisissez votre modèle Honda CB

Rechercher des pièces

Recherche dans toutes les pièces Honda CB

Exemple : oil filter (filtre à huile) ou une référence OEM.

Consultation en cours Câbles

Pièces pour motos Honda

Choisissez votre modèle et l’année pour voir les pièces répertoriées pour votre moto.

Honda CB Speedometer Cable ~ Replaces 44830-KB4-700

$22.66 USD
51-2303
Replace your DOHC CB speedometer cable with this Speedometer Cable in black, replacing OEM #44830-KB4-700 / #44830-356-010. Made in Japan.Key Features• Speedometer cable, black•...

Honda CB1000/CB900/CB750/CB650 Speedo Gear Plug

$43.95 USD
29-0538
Keep your speedo drive gear clean with this Speedo Gear Plug, 15mm outer diameter, 22mm long.Key Features• Speedo gear plug• 15mm outer diameter, 22mm...

1982 Honda CB450TC · Speedometer Cables Buying guide

Match both cable connections before replacing it

The Japanese-made cable uses references 44830-KB4-700 and 44830-356-010. Compare the installed gauge and drive connections, and distinguish a cable repair from a fault inside the speedometer or wheel drive.

Check which part of the drive needs attention

Before ordering a cable for a failed or erratic speedometer, inspect the cable and the connections at both ends using the service manual. Keep the wheel drive and instrument in the assessment. Replacing a cable should follow diagnosis rather than assume that every reading problem starts inside the cable.

Allow for changes to the motorcycle

The cable’s original-model application is useful when the gauge and wheel drive remain the matching type. A custom instrument, altered route or changed front wheel needs a direct comparison. Verify the end connections and available route rather than assuming a single cable serves every modified arrangement.

Buying questions

Which replacement references identify this cable?

The black Japanese-made cable identifies 44830-KB4-700 and 44830-356-010. Compare those references with the installed speedometer arrangement, especially when its gauge or wheel drive is no longer original.

Can I use it with a custom speedometer?

First verify the custom gauge’s cable connection, drive requirements and intended routing. The cable’s listed motorcycle fitment does not establish that every replacement mechanical gauge will accept it or read correctly.

Should I order a cable for an erratic speedometer reading?

Inspect the cable, its end connections, the wheel drive and the instrument first. Use the service manual to establish which component needs attention, then choose the replacement cable if the inspection supports that repair.

Vous ne savez pas quelle pièce choisir ?

Envoyez-nous le modèle et l’année de votre moto, des photos de la pièce actuelle et les détails de toute modification par rapport au montage d’origine.

Poser une question sur la compatibilité

Votre panier

×