2006 Honda CB900F 919 — Housses de selle et fixations
Seat setting rubber B replaces a cushion between the seat and frame on the 2006 Honda CB900F 919. It is sold individually. Match reference 77205-286-000 and inspect the installed seat base to count the cushions required for your particular repair.
Replace those worn, dried-out seat rubbers under your classic Honda with this Seat Setting Rubber "B", a direct replacement for OEM #77205-286-000. One of...
Replace the B support without overlooking the other cushions
Honda's 2006 seat listing uses one B-type rubber, 77205-286-000, alongside three other seat cushions, 77206-GF0-000. The sold-each B rubber replaces its own support; it is not a complete seat-rubber set.
Honda's 2006 seat listing uses one B-type rubber, 77205-286-000, alongside three other seat cushions, 77206-GF0-000. The sold-each B rubber replaces its own support; it is not a complete seat-rubber set.
Check the latch after refitting
The 2006 owner's manual shows the front seat prong engaging the fuel-tank stay and the rear prongs engaging their stays before the rear is pressed down to latch. After fitting a rubber, check that the seat is secure; a cushion cannot correct a misaligned hook or damaged latch.
Practical questions
How many B rubbers does the original seat use?
Honda lists one 77205-286-000 for the 2006 seat. It is supplied individually, so one replaces the original B support. That count does not include the three differently numbered seat cushions.
Why might the seat still move after replacing the B rubber?
The other cushions, seat base, hooks or latch may need attention. Check all support points and secure engagement instead of adding extra B rubbers to compensate for another fault.
Will the original-bike count apply to a custom seat?
Only if it retains the original support arrangement. Compare the replacement seat base and its mounting instructions; the Honda count describes the original seat, not every aftermarket base.
Vous ne savez pas quelle pièce choisir ?
Envoyez-nous le modèle et l’année de votre moto, des photos de la pièce actuelle et les détails de toute modification par rapport au montage d’origine.