Honda motorcycle parts
Choose your model and year to see parts listed for your bike.
Choose your model and year to see parts listed for your bike.
1970 Honda SL350K0 · Ignition Parts Buying guide
The replacement switch uses a round six-hole, four-wire plug. Separate left and right contact points are available, while the linked single-output coil has its own resistance, lead and mounting specifications to compare.
Round-plug ignition switchRound six-hole, four-wire connector; match the harness connector before ordering.View part
Left-side contact pointLeft-side contact point; replacement references 30204-286-004 and 30202-369-154.View part
Right-side contact pointRight-side contact point; replacement references 30203-286-004 and 30203-369-154.View part
Related parts: Ignition condenser · Single-output 5-ohm ignition coil
The left point uses references 30204-286-004 and 30202-369-154; the right point uses 30203-286-004 and 30203-369-154. Record which side you need before ordering. The separately linked condenser is another component, so do not infer a full ignition-service kit from either point entry.
The linked 5-ohm coil is a 12 V single-output unit, sold individually, with approximately 80 mm mounting centers and a 19-inch plug lead. It has a 6.5-inch blue lead with dual female bullets and a 5.25-inch black/white lead with a male bullet. Compare the actual ignition’s resistance requirement and connections.
They are separate entries with distinct replacement references. The left point starts with 30204-286-004 and the right with 30203-286-004. Identify the side being repaired rather than ordering two identical pieces on appearance alone.
Check the ignition’s required primary resistance, approximately 80 mm mounting centers and attached lead connections. The linked coil is 12 V and 5 ohms. The separate 3.3-ohm coil is another choice, so an electronic conversion must follow its manufacturer’s coil requirement.
A round housing is only one detail. This switch has a six-hole, four-wire plug. Compare terminal locations and the circuit connections with the fitted loom before ordering, using the correct wiring information for any conversion.
Send your model and year, plus photos of your existing part and any changes to the original setup.
Select your exact model and year to narrow your results.
Choose your model and year.