Electrical repairs on the 1976 CB360T start with identifying the affected circuit. A damaged fuse box, a front brake-light switch and a corroded starter lead need different replacements. Compare the existing connections before choosing parts for a standard or altered harness.
Replace your rear brake light switch with this Rear Brake Light Stop Switch. Exceptionally broad fitment across the SOHC CB750 lineup and virtually the...
Fit the square-plug ignition switch on your mid-'70s Honda with this Ignition Switch (square 4-prong plug type), replacing OEM #35100-374-007 / #35100-369-740 / #35100-341-700....
Replace your starter motor terminal cover with this Starter Motor Terminal (Cover) Rubber Boot, replacing OEM #32411-230-000.Key Features• Starter motor terminal rubber boot• Replaces...
Fit the front brake / clutch safety switch on your classic Honda with this Front Brake & Clutch Safe-T-Switch, replacing OEM #35340-329-003. Used on...
Restore your mid-'70s Honda's stock reflectors with this Stock-Type Screw-On Reflector with a 6mm thread, replacing OEM #33741-340-670. Broad fitment covering the 1972-78 CB750...
Replace the gasket on your 1972-onward Honda's tail light lens with this Tail Light Lens Gasket, replacing OEM #33709-341-671. Matches the fitment of our...
Replace your starter clutch diode with this Stator Clutch Diode/Rectifier, replacing OEM #31700-124-003 / #31700-166-008. Exceptionally broad fitment across the SOHC and DOHC CB750...
Restore headlight mounting with this Headlight Setting Collar, replacing OEM #61304-292-000. Exceptionally broad fitment across the classic Honda lineup, from the SOHC and DOHC...
Replace your late-'70s CB starter solenoid with this Starter Solenoid Relay, replacing OEM #35850-375-000 / #35850-286-027. Broad fitment across the late SOHC CB750, CB500T/CB550...
Seal up your starter motor with this Starter Motor Seal, size 60 x 1.4, replacing OEM #31206-286-158 / #31206-402-008. Exceptionally broad fitment across the...
Replace your front stop switch sub harness with this Front Stop / Brake Switch Sub Harness, replacing OEM #35345-319-000.Key Features• Front stop / brake...
Service your early CB750 or classic twin turn signal with this Turn Signal Lamp Gasket, replacing OEM #33443-268-671. Pairs with our signal lens #11-2110...
Replace your CB350, CB360, CB450, or CB500T rectifier with this Rectifier with female connector, replacing OEM #31700-455-671 / #31700-358-305 / #31700-358-013 / #31700-292-008 /...
Fit the European-spec left-side handlebar switch on your CB400F or CB360 with this European Version (8-wire) Bar Switch Assembly for the Clutch Side in...
Match the right-side point with this Left-Side Contact Point, replacing OEM #30204-286-004 / #30202-369-154. Same fitment as the paired 14-0005 right-side point.Key Features• Left-side...
Fit an extended-length rear signal stay with this Rear Signal Lamp Stay in chrome, 125mm long, replacing OEM #33441-369-000. This is longer than the...
This aftermarket fuse box assembly replaces Honda OEM 32110-369-013 for the listed Honda CB360 models. A tired fuse box can cause weak connections, intermittent...
Replace a worn, damaged, or corroded starter motor cable with this aftermarket cable made to replace Honda OEM 32410-286-000. This heavy starter lead carries...
Fit the Tommaselli look to your smaller-bore Honda with these 32-34mm Tommaselli-Type Headlight Brackets, supplied with rubber mount inserts. Sized for 33mm fork tubes...
Upgrade your classic Honda motorcycle’s starting system with this Rick’s Electrics Brand Performance Hot Shot Starter Motor Unit — an upgraded 4‑brush permanent‑magnet starter...
Upgrade your charging system with this Rick's Electric Hot Shot Rectifier/Regulator, replacing OEM #31400-292-670 / #31700-455-671 / #31700-292-008. Combination unit works with the stock...
Upgrade your CB350 or CB360 ignition with this Performance Single Tower Ignition Coil. Single-tower high-output coil with 3.3 Ohm primary resistance and 70 kV...
The fuse box, hydraulic brake switch and heavy starter lead serve separate jobs. Start with the symptom, inspect the wiring, and use the component reference to narrow the order.
A starter that will not turn, a brake lamp that stays dark and intermittent general electrical power need different checks. Use the Honda wiring diagram to trace the affected circuit before replacing parts, especially if earlier repairs have changed connector housings or wire routes.
Keep replacement types distinct
The featured fuse box replaces the CB360T assembly. For charging repairs, the linked rectifier is a separate component with a female connector. Compare the fitted connectors and determine whether the motorcycle still uses separate regulation before choosing parts; combined units also require a battery-chemistry check.
Electrical questions
Does the fuse-box reference apply to the 1976 model?
Yes. Honda’s T-76 parts column identifies 32110-369-013, with one fuse box per motorcycle. Compare the fitted connector and mounting points as well, particularly if the wiring has been replaced.
Which brake-light switch belongs at the front?
The stock disc-brake arrangement uses a hydraulic switch. The featured replacement has an M10 × 1.25 thread; the separately linked rear switch operates at the brake pedal and serves a different mounting location.
Should a weak starter automatically be replaced?
No. Inspect the battery, cable connections and heavy starter lead before choosing a motor. The featured cable is an individual replacement lead; check its route and terminal ends against the existing installation.
Not sure which part you need?
Send your model and year, plus photos of your existing part and any changes to the original setup.