Honda motorcycle parts
Choose your model and year to see parts listed for your bike.
Choose your model and year to see parts listed for your bike.
1972 Honda CB450K · Ignition Systems, Coils & Plugs Buying guide
The individually sold coil is 12V, single output and 5-ohm primary, with attached wiring. Both cap choices are aftermarket parts sold each without stated resistance values. Contact points identify separate left and right references, while the condenser names its own replacement references.
Single-output coil with measured leads12V coil, 5-ohm primary and 19-inch spark plug wire, sold each with leads attached. Mounting centres are approximately 80mm. Compare its wiring and bracket arrangement, including the reversed-mounting note for a beige Honda coil.View part
Aftermarket cap with connection checksVB05F spark plug cap sold each for the listed Honda applications. Its description asks for electrical and connection checks without supplying cap resistance or full terminal dimensions. Match it to the plug, lead and ignition being used.View part
Aftermarket cap for restoration or custom workYB05F cap sold individually and described for restoration or custom work. Confirm the plug and ignition-lead connection, plus any required resistance specification missing from the description, before selecting it.View part
Related parts: Left-side contact point replacement · Right-side contact point replacement · Condenser reference and connection check
The coil specifies a 6.5-inch blue wire with dual female bullet connector and a 5.25-inch black/white wire with male bullet connector. Assess those lengths alongside its 19-inch plug wire and mounting orientation. Where a bracket or harness has changed, confirm the paths and connections needed by the retained ignition.
The left point references 30204-292-003 / 30204-292-154 and the right point 30203-292-003 / 30203-292-154. The condenser uses 30250-369-004 / 30280-292-672 / 30280-292-671. Read supplied quantities before treating these separate descriptions as a combined pair or service kit.
Neither cap description gives a resistance value. Confirm the requirement for the plug, ignition lead and ignition system being retained before choosing between them. Do not infer a value from the cap designation or use the coil’s primary resistance as a cap specification.
Check the approximately 80mm mounting centres and the wire exits against that bracket, then compare all stated lead lengths and bullet connectors with the retained wiring. The listing’s beige-coil replacement note changes mounting orientation; bracket spacing alone cannot resolve the lead route.
The left and right products have distinct 30204-292 and 30203-292 references. Compare the component and side being repaired and confirm each purchase’s supplied quantity. The shared motorcycle application does not turn one point listing into an explicit two-sided package.
Send your model and year, plus photos of your existing part and any changes to the original setup.
Select your exact model and year to narrow your results.
Choose your model and year.