Honda motorcycle parts
Choose your model and year to see parts listed for your bike.
Choose your model and year to see parts listed for your bike.
1971 Honda CB450K · Electrical Buying guide
The coil provides mounting and lead specifications; the hydraulic stop switch provides a thread size. Charging controls distinguish standard lead-acid and lithium-ion batteries. Smaller lighting and wiring parts need their own mounting checks rather than a single assumption about the whole motorcycle.
12V ignition coil with attached leadsSingle-output coil with a 5-ohm primary, approximately 80mm mounting centres and a 19-inch spark plug wire. Sold each. Compare the fitted ignition, wiring and mounting, including the instruction for replacing a beige Honda coil.View part
Threaded hydraulic stop-light switchFront hydraulic stop switch referencing Honda 35350-300-006 / 35350-300-016, with M10 × 1.25 thread. Check the actual threaded port and electrical connection before choosing it for the retained brake arrangement.View part
Lead-acid combination charging controlHot Shot rectifier/regulator described for the existing stator and standard lead-acid batteries. It expressly excludes lithium-ion use. Compare the fitted charging connections and mounting before selecting this version.View part
Related parts: Left bar switch with external wiring · Individually sold aftermarket plug cap · Genuine Honda amber fork reflector
The fork reflector has a threaded post, while the front reflector base, signal stay and lens gaskets address other attachments. Compare each with the component retained on the motorcycle. An ignition or charging repair does not identify the lamp housing, reflector mount or gasket required elsewhere.
The VB05F cap is sold each and asks for electrical and connection checks, but its description gives no resistance value or terminal dimensions. Establish the cap requirements from the plug, lead and ignition you will use. The coil’s 5-ohm primary specification does not supply a cap specification.
The genuine Honda reflector names reference 33741-315-000 and superseded references 33741-286-670 / 33741-045-671, with a small-diameter amber face and threaded post. Compare the retained mounting; numerical face and post dimensions are not given, so confirm any measurements needed for a changed bracket.
Its description specifies wiring outside the handlebar. Assess that route with the controls and wiring you intend to keep. Internal routing or a changed handlebar requires a separate compatibility check; no internal-routing conversion is documented by the listing.
Choose the charging version for the replacement battery rather than the old installation. Lead-acid versions exclude lithium-ion use; lithium versions exclude standard lead-acid batteries and specify 14V ±0.2. Confirm that set point with the lithium battery manufacturer before choosing the equipment.
Send your model and year, plus photos of your existing part and any changes to the original setup.
Select your exact model and year to narrow your results.
Choose your model and year.