Honda motorcycle parts
Choose your model and year to see parts listed for your bike.
Choose your model and year to see parts listed for your bike.
1972 Honda CB500K · Wheel Spokes & Service Parts Buying guide
Front spokes are assigned to the stock 19-inch wheel; the rear pack specifies an 18-inch wheel and forty nipples. Keep the left rear bearing retainer separate from spoke purchases when checking what the repair needs.
40-spoke stock front-wheel packSilver bright cadmium-plated steel spoke set for the stock 19-inch CB500K front wheel. Forty spokes are stated per pack; use the matching stock front-hub application.View part
40 spokes and nipples for rear wheelStock 18-inch rear-wheel pack with forty silver spokes and forty gold-colored nipples. Keep this rear application distinct from the front-wheel set.View part
Left rear bearing retainerRetainer referencing 41231-323-020 for the rear wheel’s left bearing position. It is a retaining component rather than a bearing, seal or complete wheel-service kit.View part
The front source describes forty bright cadmium-plated steel spokes for the stock 19-inch CB500K wheel, with silver spokes and nipples. The rear explicitly lists forty silver spokes and forty gold-colored nipples for the stock 18-inch rear wheel. Compare the actual hub and rim if either wheel has been converted.
The rear retainer references 41231-323-020 and is described for the left bearing position. It does not replace a bearing or wheel-drive rubber. Inspect the existing assembly and read the required component’s contents before ordering; engine primary-drive rubber also serves a different assembly despite being an eight-piece damper set.
The front pack supplies 40 spokes with matching nipples for the stock 19-inch wheel, all silver-colored. The stock 18-inch rear pack supplies 40 silver spokes and 40 gold-colored nipples; select the correct wheel position.
Rim diameter alone does not establish fit. The pack is specified for the stock CB500K rear wheel; compare hub dimensions, spoke angles, lengths and rim drilling before using that application for a changed hub or rim.
One 41231-323-020 retainer is supplied for the left rear-wheel bearing location. Opposite-side hardware is excluded and is not interchangeable unless the parts diagram specifies the same reference; check the actual hub position before ordering.
Send your model and year, plus photos of your existing part and any changes to the original setup.
Select your exact model and year to narrow your results.
Choose your model and year.