Seat setting rubber B is offered for the 2007 Honda CB900F 919 as an individual seat-to-frame cushion. Compare reference 77205-286-000 and inspect the underside of the installed seat. Count the required matching pieces before ordering because no 919-specific total is provided.
Replace those worn, dried-out seat rubbers under your classic Honda with this Seat Setting Rubber "B", a direct replacement for OEM #77205-286-000. One of...
2007 Honda CB900F 919 · Seat Support Cushions Buying guide
Replace the B support without overlooking the other cushions
Honda's 2007 seat listing uses one B-type rubber, 77205-286-000, alongside three other seat cushions, 77206-GF0-000. The sold-each B rubber replaces its own support; it is not a complete seat-rubber set.
Honda's 2007 seat listing uses one B-type rubber, 77205-286-000, alongside three other seat cushions, 77206-GF0-000. The sold-each B rubber replaces its own support; it is not a complete seat-rubber set.
Check the latch after refitting
The 2007 owner's manual shows the front seat prong engaging the fuel-tank stay and the rear prongs engaging their stays before the rear is pressed down to latch. After fitting a rubber, check that the seat is secure; a cushion cannot correct a misaligned hook or damaged latch.
Practical questions
How many B rubbers does the original seat use?
Honda lists one 77205-286-000 for the 2007 seat. It is supplied individually, so one replaces the original B support. That count does not include the three differently numbered seat cushions.
Why might the seat still move after replacing the B rubber?
The other cushions, seat base, hooks or latch may need attention. Check all support points and secure engagement instead of adding extra B rubbers to compensate for another fault.
Will the original-bike count apply to a custom seat?
Only if it retains the original support arrangement. Compare the replacement seat base and its mounting instructions; the Honda count describes the original seat, not every aftermarket base.
Not sure which part you need?
Send your model and year, plus photos of your existing part and any changes to the original setup.