The two support rubbers in this 2007 Honda CB900F 919 selection are seat setting rubber B and the front tank holder. Both are sold individually. Match the reference and mounting location, then count the seat cushions directly and the front tank holders from their stated requirement.
Replace those worn, dried-out seat rubbers under your classic Honda with this Seat Setting Rubber "B", a direct replacement for OEM #77205-286-000. One of...
2007 Honda CB900F 919 · Support Rubbers Buying guide
Separate seat cushioning from front tank support
The B seat rubber and front tank-holder cushion are sold individually, but their original-bike quantities differ. Match the mounting position before using a quantity from another part of the motorcycle.
Honda's 2007 seat listing uses one B-type rubber, 77205-286-000, alongside three other seat cushions, 77206-GF0-000. The sold-each B rubber replaces its own support; it is not a complete seat-rubber set.
The front pair is only part of the tank mounting
The original 2007 tank uses two front cushions, 17611-425-000. Each offered rubber is one cushion, so order two to renew both front supports. The rear pivot and rear cushion are separate parts. Check the supports and mating surfaces for damage before refitting the tank.
Practical questions
Can the seat and tank rubbers be used interchangeably?
No. Seat rubber B replaces 77205-286-000; the front tank cushion replaces 17611-425-000. They serve different mounting points and are not alternative shapes for the same job.
How many front tank rubbers should I order for a complete front pair?
Two. The offered part is sold each and the original tank uses two at the front. The rear pivot and rear cushion require their own correct parts if worn.
Will replacing the front rubbers cure every loose-tank problem?
No. Inspect the rear supports and the condition of the mounting points too. New cushions will not repair a damaged bracket or compensate for a changed tank's mounting arrangement.
Not sure which part you need?
Send your model and year, plus photos of your existing part and any changes to the original setup.