My motorcycle Choose your Honda CB model

Search parts

Searching all Honda CB parts

Example: brake pads or oil filter.

Currently viewing Foot Pegs, Gear Lever, Kick Starter, Side Stand & Center Stand

Honda motorcycle parts

Choose your model and year to see parts listed for your bike.

Honda CB Kick Stand Stopper Rubber ~ Replaces 95011-61000

$2.95 USD
07-4624
Replace a worn kick stand stopper with this Kick Stand Stopper Rubber "A", a direct replacement for OEM #95011-61000. Exceptionally broad fitment across the...

Honda CB Side Stand Pivot Bolt & Nut Set ~ Replaces 90108-283-000

$4.61 USD
73-0893
Replace your side stand pivot hardware with this Side Stand Pivot Bolt & Nut Set, used to fasten the side stand in place. Replaces...

1970 Honda SL350K0 · Side Stand Hardware Buying guide

Check the pivot and stop as separate jobs

The pivot hardware and rubber stop are two different service choices. Compare each with the part on the motorcycle; do not infer a complete stand assembly from either item.

Do not use new hardware to conceal mounting damage

Photograph the stand pivot before dismantling it and retain the old pieces for comparison. If the mounting surfaces are damaged or the replacement cannot be positively matched, have the assembly checked before use. New hardware alone does not establish that the stand is serviceable.

Account for earlier exhaust or stand changes

Compare the actual stop location as carefully as the pivot. A motorcycle with changed stand or exhaust components may not retain its original arrangement. Use the stopper reference and the existing mount to identify the part rather than assuming every visible rubber serves the same purpose.

Ordering questions

Is the pivot fastener supplied with its nut?

Yes. The pivot item is a bolt-and-nut set, with separate replacement references for the two pieces. Compare both with the existing assembly; a previous repair may have introduced different hardware.

Should I order the stopper whenever I replace the pivot bolt?

Inspect the stopper independently. The bolt-and-nut set addresses the pivot, while the rubber addresses the stand stop. Choose the pieces needed for the condition and arrangement on your motorcycle rather than treating them as a mandatory combined kit.

What if my stand still has play with a new bolt?

Stop and have the pivot and its mounting surfaces assessed. The available set supplies replacement hardware, but its description does not establish a repair for damaged stand or frame mounting points. Follow the appropriate service information for inspection.

Not sure which part you need?

Send your model and year, plus photos of your existing part and any changes to the original setup.

Ask a fitment question

Your cart

×