Honda motorcycle parts
Choose your model and year to see parts listed for your bike.
Choose your model and year to see parts listed for your bike.
1974 Honda CL450K6 · Ignition Service Parts Buying guide
The coil supplies measurable mounting and lead details; the condenser and linked points use distinct replacement references. Establish the fitted ignition system before interpreting these products as a suitable group of service parts.
Single-output ignition coil12 V coil with 5-ohm primary resistance, attached wires and approximately 80 mm mounting-hole centers. Sold each.View part
Replacement ignition condenserReplacement references 30250-369-004, 30280-292-672 and 30280-292-671.View part
Related parts: Left-side contact point · Right-side contact point
The coil is a 12 V single-output unit with 5-ohm primary resistance, approximately 80 mm mounting centers and attached wires. Its description notes different wire exits from a beige Honda coil. Assess routing and clearance before purchase rather than assuming the replacement will sit exactly as the old unit did.
The linked left point lists 30204-292-003 and 30204-292-154; the right lists 30203-292-003 and 30203-292-154. Keep those identities distinct on the order. The descriptions do not supply timing or point-gap settings, so use the appropriate service information for the installed ignition system.
The product supplies a 5-ohm primary-resistance specification. Compare it with the conversion manufacturer’s requirements, along with voltage, outputs and wiring; a model application alone does not establish compatibility with an altered ignition system.
The products are explicitly left-side and right-side items with different references. Select the positions required by the service plan instead of treating one side’s listing as an identified left-and-right package.
Check the replacement’s wire-exit arrangement, lead lengths and clearances against the existing installation. The source notes a routing difference, so obtain the correct fitting instructions before assuming the old mounting orientation can be copied.
Send your model and year, plus photos of your existing part and any changes to the original setup.
Select your exact model and year to narrow your results.
Choose your model and year.