Honda motorcycle parts
Choose your model and year to see parts listed for your bike.
Choose your model and year to see parts listed for your bike.
1980 Honda CB400TA Hawk · Starter & Charging Parts Buying guide
Before replacing a charging unit, identify the battery chemistry and inspect both connector blocks. When servicing the starter, use the correct seal dimensions and check the condition of the terminal boot.
Six-wire rectifier/regulatorThree yellow wires share one connector; the other three wires use a four-space block. Match both connections to your loom.View part
Lithium-only rectifier/regulatorRick’s unit has a 14 V ±0.2 set point and omits the black signal wire. Not for standard lead-acid batteries.View part
Starter terminal rubber bootRubber terminal cover replacing reference 32411-230-000. Check the cover and cable opening against your starter connection.View part
Related parts: 60 × 1.4 starter seal · 24.4 × 3.1 starter seal
The six-wire replacement uses three yellow wires in one block and three wires in a four-space block. Rick’s lithium-only alternative omits the black signal wire and has a 14 V ±0.2 set point. Check that requirement with the battery manufacturer; it is unsuitable for standard lead-acid batteries.
The related starter seals measure 60 × 1.4 and 24.4 × 3.1; Honda lists them at separate positions. Choose the ring for the joint being serviced rather than treating the two as alternatives. Inspect the terminal boot during the same work and retain sound connections.
Only for a suitable lithium-ion battery whose manufacturer approves the 14 V ±0.2 set point. Rick’s expressly excludes standard lead-acid batteries. Confirm the battery requirement and wiring before selecting this unit.
No. The linked 60 × 1.4 and 24.4 × 3.1 seals correspond to separate starter positions in Honda’s diagram. Match the joint being opened and its reference instead of choosing whichever ring looks closest.
Compare the boot’s terminal recess and cable opening with your existing starter connection. Check the retained cable, terminal and surrounding clearance, particularly if the starter or wiring has been replaced, before choosing the cover.
Send your model and year, plus photos of your existing part and any changes to the original setup.
Select your exact model and year to narrow your results.
Choose your model and year.