My motorcycle Choose your Honda CB model

Search parts

Searching all Honda CB parts

Example: brake pads or oil filter.

Currently viewing Throttle/Choke Cables, Throttles & Sleeves

Honda motorcycle parts

Choose your model and year to see parts listed for your bike.

Honda CB750 / CB550 / CB500 Throttle Cable ~ Pull ~ Replaces 17910-341-000

$25.95 USD
51-2505
Replace your CB750 throttle pull cable with this Throttle Cable "Pull Type", replacing OEM #17910-341-000. End-to-end length 40". Made in Japan.Key Features• Throttle cable,...
Sold out
Honda CB throttle sleeve 53141-300-010

Honda CB Throttle Sleeve ~ Replaces 53141-300-010

$9.95 USD
02-2462
Refresh the throttle feel on your Honda with this Nylon Throttle Sleeve, a replacement for OEM Ref. #53141-300-010 with exceptionally broad fitment across the...

1977 Honda CB550F · Throttle Pull Cable & Sleeve Buying guide

Locate the control problem before replacing the cable or sleeve

Inspect the sleeve in its housing and the cable along its fitted path. Altered handlebars can affect required cable reach, while changed controls can affect the connection and space at the twistgrip.

Compare like-for-like cable measurements

The replacement pull cable is specified as 40 inches end to end. Compare that with the whole existing cable, not just the outer casing. The path to the fitted controls matters as well; a moved or raised handlebar can change the required reach and available clearance.

Check the sleeve without overlooking the cable

The nylon sleeve renews a part at the twistgrip, while the cable carries the control movement to the carburetors. Inspect both instead of assuming a new sleeve resolves a cable fault. After fitting suitable parts, verify smooth throttle movement and return through the steering range.

Your buying questions

How should I compare a cable after the handlebars have been changed?

Compare its two connections and the full routed path, then check the stated 40-inch end-to-end length. A matching year application does not establish suitable reach for a different bar position. Confirm the route without tension or binding.

What does the pull-type description tell me to check?

It identifies the cable function being replaced. Match that function and the end connections on your controls and carburetors. Do not treat a pull cable as another throttle-cable type simply because the lengths look similar.

Can a worn throttle housing be renewed by the sleeve alone?

The sleeve is a separate nylon part, not a complete housing. Inspect the housing and cable independently before planning the repair. A new sleeve cannot replace damaged surrounding hardware.

Not sure which part you need?

Send your model and year, plus photos of your existing part and any changes to the original setup.

Ask a fitment question

Your cart

×