Honda motorcycle parts
Choose your model and year to see parts listed for your bike.
Choose your model and year to see parts listed for your bike.
1972 Honda CB750K · Starter & Charging System Buying guide
The starter relay, alternator stator and combined regulator/rectifier are different purchases. A combined unit can also have its own mounting requirements, so check the individual listing before treating it as a direct physical substitution.
Starter solenoid relayReplacement starter relay listed for the 1972 CB750K, with Honda 35850-371-670 among its stated replacement references.View part
Stock-style alternator statorStock-style stator listed for the SOHC CB750, with Honda 31102-300-045 and 31102-300-035 among its replacement references.View part
Rick’s regulator/rectifierCombined regulator/rectifier with stock-type plugs and instructions; 68 × 94 × 26 mm, with 80 mm mounting-hole centres. Custom mounting may be needed.View part
The featured combined unit is specified at 68 × 94 × 26 mm, with mounting holes 80 mm apart centre to centre. Compare available space and the mounting arrangement before purchase. Its stock-type plugs do not make the housing a guaranteed match for the original mount.
This range includes a relay, starter motor, brush and seal products, and starter-clutch service parts. Those are different assemblies rather than a single overhaul package. Use the installed component and workshop guidance to identify the job, then read the selected product’s contents before deciding whether you need a complete replacement or service pieces.
The featured listing says a custom mounting job may be required and supplies its dimensions and mounting-hole spacing. Read its installation instructions and compare your motorcycle’s arrangement before choosing where to mount it.
The separate lithium-ion regulator explicitly excludes standard lead-acid batteries and specifies a 14 V ±0.2 set point. Confirm its requirements against the actual battery before purchase; it is not a general substitute for every regulator in this category.
The brush set is specified for a Mitsuba two-brush starter and supplies two 12 × 14 × 6 mm brushes, one with an insulated lead and one with a non-insulated lead. The Rick’s replacement motor uses a four-brush design. Identify the installed motor before selecting service parts.
Send your model and year, plus photos of your existing part and any changes to the original setup.
Select your exact model and year to narrow your results.
Choose your model and year.