Honda motorcycle parts
Choose your model and year to see parts listed for your bike.
Choose your model and year to see parts listed for your bike.
1969 Honda CL450K2 · Electrical Buying guide
The available choices include a round-plug ignition switch, service parts for a two-brush starter and lighting hardware. Match the faulty assembly first so that a shared catalog category does not become a wiring decision.
Round-plug ignition switchRound six-hole plug with four wires; compare the harness connector and terminal positions before ordering.View part
Single-output ignition coil12V, 5-ohm coil with attached wires and approximately 80mm mounting-hole centers. Sold individually.View part
Rear brake-light switchReplacement rear brake-light stop switch. Compare its attachment and electrical connection with the existing assembly.View part
An ignition switch, starter brush set and rear brake-light switch serve different circuits. Establish which component needs attention before ordering. A replacement harness or starter can change the required connector or brush arrangement even when the motorcycle retains its original frame and engine.
Follow the relevant ignition, headlight, signal or charging category to compare the matching service pieces. Keep electrical specifications tied to the component being purchased; a 12V label by itself does not establish coil resistance, rectifier pin mapping or switch wiring.
The featured switch has a six-hole round plug with four wires. Compare the occupied positions and circuit assignments as well as the shell; a replacement harness can retain a similar-looking connector.
The replacement is a 12V, single-output, 5-ohm coil with approximately 80 mm mounting centers and a 19-inch spark-plug wire. It is sold individually. Compare lead routing and any modified ignition system before ordering.
Compare its mounting arrangement, operating connection and wiring with the switch on the motorcycle. The catalog does not provide a connector diagram or dimensions sufficient to identify every replacement assembly.
Send your model and year, plus photos of your existing part and any changes to the original setup.
Select your exact model and year to narrow your results.
Choose your model and year.